Drawer Runners

 

1. Lay out the Drawer Bottom and the Drawer Rear.
Note: See this image: The Drawer Rear is now attached to the Drawer Bottom with CAM Fittings (rather than screws) to make the assembly easier.
Note: Make sure that you do not install this updside down - You can see that the Drawer Runner holes are at the bottom of the Drawer Bottom. An easy way to check this is to ensure that both the part labels are to the outside of the Drawer Runner and NOT on the inside!

IMPORTANT NOTE: The cam holes are drilled from the bottom of the drawer bottom. They are designed to drill all of the way through so that they pop out of the top face. The drill hole is designed to drill through by a marginal amount of just 0.2mm, however in some cases it may appear that the drill bit has not gone all the way through. You should find that by simply pressing with your finger where the drill has not gone 100% through, will open up the hole so that you can insert the cam fitting correctly on the top face. 
Once assembled, your drawer back and drawer base should look like the image below (with the drawer runner attachment holes on the bottom face):
 

 

2. Metal Drawer Runners and the screws needed. Now screw these to the Drawer Runner Rear and Bottom.

 

3. Install the Drawer Runners into the cabinetry